Transmitter system setup

Follow

The TX transmitter settings can be accessed via the menu. Once in the menu it is possible to change settings according to your personal preferences and operating requirements. Some examples of setting changes are shown below.

Before changing settings, ensure the transmitter is switched on by pressing thepower keykey for two seconds.

Language

The transmitter support's a number of languages. You can specify your preferred language using the menu system.

To select your preferred menu language:

  1. Press the power key key to enter the menu.
  2. Scroll to the LANG menu using the up arrow or down arrow keys.
  3. Press the measure key key on the transmitter to enter the LANG menu.
  4. Scroll through the language options using the up arrow or down arrowkeys.
  5. Press the frequency key key to accept your selection and return to the main menu.
  6. Press the power keykey to return to the main operation screen.

 

Battery Type

TX transmitters support Lithium-Ion, Alkaline or Nickel Metal Hydride batteries.

You should set the transmitter battery type to match the currently installed type. This is to ensure optimal performance and correct battery level indication.

 

To set your battery type:

  1. Press the power keykey to enter the menu.
  2. Scroll to the BATT menu using the up arrow or down arrowarrows.
  3. Press the measure key key to enter the BATT menu.
  4. Scroll through the battery options using the up arrowor down arrowkeys.
  5. Press the frequency keykey to accept your selection and return to the main menu.
  6. Press the power keykey to return to the main operation screen.

 

Enabling / Disabling Frequencies

The transmitter support's a wide range of frequencies and there may be times when some of these frequencies are not used. It is possible to quickly enable or disable frequencies using the menu system.

To enable or disable frequencies:

  1. Press the power keykey to enter the menu.
  2. Scroll to the FREQ menu using the up arrow or down arrowkeys.
  3. Press the measure keykey on the transmitter to enter the FREQ menu.
  4. Scroll through the frequency options using the up arrow or down arrowkeys.
  5. Press the measure keykey on the transmitter to enter the frequency.
  6. Scroll to OFF or ON using the up arrow or down arrowkeys.
  7. Press the frequency keykey to accept your selection and return to frequency menu.
  8. If you wish to make any further changes follow steps 4 to 6. If you do not wish to make any further changes press the frequency keykey twice to return to the main operation screen.

 

Volume Control

The transmitter features an internal speaker to provide critical warnings and assist with cable and pipe location.

To adjust audio level:

  1. Press the power keykey to enter the menu.
  2. Scroll to the VOL menu the up arrow or down arrowarrows.
  3. Press the measure keykey transmitter to enter the VOL menu.
  4. Scroll through the volume options using the up arrow or down arrowkeys.
  5. Press the frequency keykey to accept your selection and return to the main menu.
  6. Press the power keykey to return to the main operation screen.

 

Share this Article

Was this article helpful?
0 out of 0 found this helpful

Comments